9 best car holders

With the advent of navigators in modern smartphones, it became necessary to keep them in sight, even when you are driving. This requires a simple thing - a holder for the phone. If she had not yet broken and fell off at full speed! To stick it back is easy, but the touch screen may not survive the fall. So this small accessory needs to be chosen with special attention. And the more expensive your smartphone, the more severely you have to select applicants. The right decision would be to read reviews of happy (or unfortunate) owners of various holders, which we did. The result was a kind of TOP best auto accessories for smartphones, divided by the method of attachment in the cabin.

Car holder for phone which company choose

A good holder cannot be cheap, so car accessories from only the most famous manufacturers were included in our rating.

These manufacturers include:

1. Onetto

2. Ppyple Inc. Korea

3. Belkin International, Inc.

4. Kenu

5. iOttie, Inc.

6. Nite ize

Products of these manufacturers are of high quality, reliability and ease of use. Firms are constantly introducing their new developments that make simple phone holders really comfortable. So the cost of the original models from these brands is quite justified.

The best car holders for the phone with attachment to the deflector

Holders of these types are attached to the air ducts in the cabin with the help of special pegs, clips or spring-loaded legs. In this case, the phone becomes available both for the driver and the passenger, and most importantly, it does not block the view.

Onetto One Touch Vent Mount Easy

Strong, powerful, no backlash - about as it is characterized by motorists. The plastic holder is designed for phones with a width of 61-86 mm, and its blades are profuter with silicone pads. The fastener clings well to the deflector plates with a thickness of up to 5 mm, and the working part of the accessory is seated on a hinge with a stopper. "Load" of this model - 250 g

Pros:

• The ability to rotate the holder with the phone at 360 °;
• Additional stop at the bottom;
• Rubber mounting does not scratch the duct grille, but clings tightly;
• Spring-loaded legs are closed - you just press the phone to the release button.

Minuses:

• Small tilt angle - only 15 °;
• When shaking, the rigidly fixed smartphone works as a lever and can break the grille;
• The spring mechanism is not eternal and over time its grip may weaken.

In this holder any dimensional gadget is protected from damage, and strong clamps hold it even during strong shaking. But for the machine itself, it is better if you drive on a normal surface so as not to crack the deflector.

Kenu airframe

This model is more compact and simply snaps onto the grille, clasping it with four soft paws. The construction used solid plastic and stainless steel, the lining is made of good rubber. The manufacturer promises that the holder will be able to “grab” any smartphone with a diagonal of 4.8 ″ (for larger models and tablets at 6-8 ″, you can take the Airframe +).

Pros:

• Decent quality;
• The cabin is almost invisible;
• Tilt angle to 90 °;
• The ability to rotate 360 ​​°;
• Suitable for any lattice configuration;
• Reliable clips for your phone.

Minuses:

• There is no lower limit;
• Someone minimalistic design seems rustic.

Kenu's approach to the design of the holder is interesting: there is only 1 movable foot. Nevertheless, it is very convenient to insert the phone with one hand if you slide the clip with the end.

Belkin car vent mount

It looks as laconic as the Kenu modelka, only with two mobile legs. He also easily makes a full turn, and his grabs are moved apart by a width of 55-83 mm.

Pros:

• 360 degree rotation of the smartphone;
• Able to grab any phone model - up to the iPhone 7Plus;
• There is a holder for the charging cord;
• Compact size;
• Soft rubberized crimping for fixing on the grid.

Minuses:

• Missing latch bottom;
• The price is too big.

The holder is very simple, but sturdy and reliable - it just will not break itself and will not damage the deflector grating.

Nite Ize Steelie (Vent Mount version)

The device, which is attached to the air grids with universal clips, has a head with a high-power neodymium magnet. He will safely hold the phone weighing up to 300 g even during extreme driving, and you can install the gadget on it with just one touch.

Pros:

• Excellent workmanship;
• The phone does not move when shaken;
• External magnetic lining (no need to install under the cover);
• The ability to attach any other items to the holder;
• The hinge mechanism allows you to rotate the smartphone in any direction;
• Adhesive tape for the lining leaves no residue.

Minuses:

• Many cheap and unreliable imitations appeared on the market;
• The price is too high.

You have to get used to the pad on the phone case (or on the case where you paste it). It is quite voluminous, which can create inconvenience during normal use of the device.

Best car suction cup holders

Here, each driver himself decides where to attach the accessory so that it is convenient to use the smartphone and it does not block the review. Typically, such a device is attached to the glass or torpedo. But it must be remembered that in such constructions the sucker is the weak link, therefore only the most tenacious of them are in our TOP.

Ppyple Dash-N5

The compact device is “friendly” with the phones, the diagonal of which falls in the range of 3.5-5.5 ″. The manufacturer recommends attaching it directly to the dashboard using a nano-suction cup. The ridiculous word actually denotes a super-adherent jelly-like coating that does not stick to hands, but is well supported on textured and vertical surfaces. You can also sculpt it on the glass.

Pros:

• Slopes, turns - everything happens without squeaks and clicks;
• The suction cup does not leave marks on the surface and does not respond to changes in temperature;
• The phone is easily removed from the holder;
• Soft pad well dampens vibrations;
• The sucker, if necessary, is easy to clean with ordinary water;
• The holder turns, rises on a leg and turns on 360 ° thanks to the coupled hinges;
• Attractive design;
• Adequate price.

Minuses:

• Glossy models collect dust.

Available in white and black with a matte and glossy surface effect.

Onetto Mount Easy One Touch 2

In its own way, a funny, but very mobile holder on the suction cup turned out to be a very functional device. The traditional assembly for Onetto is a high-quality assembly and thick plastic here successfully complemented by a non-standard design with several degrees of freedom. The side sliding legs are designed for fastening phablets and tablets 5.5–8.9 cm wide. The length of the telescopic leg varies in the range of 10–16.5 cm.

Pros:

• The telescope allows you to bring the phone closer without removing it if the dashboard is too deep;
• The reliable gel sucker perfectly keeps on surfaces with any texture;
• It shows itself well when shaking on a primer or pavement;
• In the open position, the extension rotates by 180 °, the head of the holder - by 360 °;
• The trigger button on the bed;
• Foot lock;
• Adjustable bottom support for the phone.

Minuses:

• A rather bulky design, but this is a fee for a telescopic bar;
• The phone can be removed only with the special detach button;
• High price.

In order for the sucker to adhere well to the surface, you need to press the tongue at the base of the holder: once for fastening to glass, two - to the textured surface of the dashboard.

The best car holders for phones with installation in the CD-slot

If you almost do not use a CD player in the radio, you can adapt it to install the holder under the smartphone. So the screen will always be visible, and will not interfere with your hands.

Onetto CD Slot Mount Easy Magnetic

A tidy holder for installation in a CD slot has a magnetic head that can hold any device weighing up to 250 g. No legs and clamps, and therefore no restrictions on the size of the smartphone. The only thing - under the cover will have to install a metal disk, which will stick to the magnet. The thickness of the rear panel should not be more than 2 mm.

Pros:

• Does not interfere with playing discs in the radio;
• The rubberized retainer does not scratch the slot;
• The holder on the ball joint allows the phone to make a full turn.

Minuses:

• In some models of the tape recorder, the smartphone may block access to the top buttons;
• Magnetic mounting over time can disrupt the operation of the camera and navigation system.

A screw is installed in the lower part of the holder - it must be tightened in order to unscrew the fastening tabs in the slot.

Ppyple CD-N5

The mounting part of this holder has a special impeller, the blades of which diverge in the CD slot and there become a crack. Included are three rubber pads of different thickness (from 1.5 to 2.5 mm), allowing you to choose the optimal size for a tight fit holder in the slot.

Pros:

• Stylish;
• The paws of the holder are rubberized and do not scratch the phone;
• Easy installation / removal of the device;
• Relatively low cost;
• The holder rotates left-right and around the axis;
• It clings tightly to the CD-slot, does not play and does not jump out on the bumps.

Minuses:

• The locking lever is tight;
• After a long time of use, clamps may loosen.

iOttie iTap Car Mount Magnetic

Another magnetic holder for a disk slot is compact and convenient. Its design is simple, and the movable head allows you to tilt the phone in all directions or rotate it 360 °.

Pros:

• A powerful neodymium magnet holds the phone even when shaken;
• It is easily installed and fixed by the spacer foot in the slot of the CD;
• Also easily removed;
• Laconic and universal design;
• Does not vibrate on the go.

Minuses:

• The need to mount the response plate on the body of the smartphone;
• Relatively high cost.

Which phone holder to buy?

1. If you just drive around the city and are neat enough, you can buy a holder for Onetto's One Touch Easy deflector for overall fittables. He will keep the apparatus, and the lattice will not break.

2. For more severe roads under large gadgets, it is better to choose Belkin Car - it gently embraces the deflector. This model is suitable for those who charge the phone from the cigarette lighter, but does not want to get confused in the wires.

3. For small smartphones with a diagonal of up to 4.8 ″, the Kenu compact Airframe model will do.

4. If you do not want to spoil the interior of the car with bulky accessories, a great solution would be the magnetic holder Nite Ize Steelie with a fit on the deflector.

5. Are you actively using a smartphone while driving? Then it is better to choose a suction cup holder, say Ppyple Dash-N5, and set it in line of sight.

6. In vehicles with a deep dashboard, it is more convenient to use telescopic holders, such as the Easy One Touch 2 brand Onetto.

7. Under the used CD slot radio, you can take Mount Easy Magnetic - the same company - it will hold any phone with a neodymium magnet. For the same tasks suitable iTap Magnetic from the company iOttie.

8. To be absolutely quiet for the device even with aggressive driving on uneven roads, it is better to choose a Ppyple CD-N5 holder with wide legs to grip a navigator or smartphone.